1 key until number “1” is displayed. 3. press, Key to stop the sub-test or – HP 2566C User Manual
Page 74
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Example of a Continuous Sub-Test
To continuously run the “Standard Ripple Print” sub-test, follow the
proceeding instructions:
1. Enter CONTINUOUS TEST mode.
Press the
(
test
1 key and hold it down for more than two seconds
until the displayed number “5” changes to “4.” Release the
(
test
1
key.
2. Select the Ripple Print sub-test.
Press either
(
fine
adj
.
1 key until number “1” is displayed.
3. Press
(
enter
!
This begins the sub-test. Unless an error occurs, the sub-test will run
continuously. Press the
(
test
)
key to stop the sub-test or
(
on
line
)
to
return control of the printer to the host.
Test Failure
If there is a problem with the printer, an error number flashes in the
display window. Error numbers indicate the general area in the printer
where the failure occurs. If your printer fails the self-test, refer to
Chapter 7 for a description of error codes or the Operator Information
Label inside your printer.
PRINTER CONFIGURATION 5-9