Preparing the printer for operation – HP 2566C User Manual

Page 22

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

PREPARING THE PRINTER FOR OPERATION

This chapter will help you begin using your HP2566C/HP2567C printer.
It explains how to load the ribbon and paper, adjust your printer for
different sizes and thicknesses of paper, and set Top of Form.

Follow these instructions to install the ribbon. At this point, the
printer’s power can either be “ON” or “OFF.”

Ribbon Removal and

Replacement

Tools are not required to remove or replace the ribbon. The printer
uses a towel-type ribbon (9282-0545) which is easily installed. Refer to

Appendix C, “Ribbon Specifications,” to verify that the ribbon being

replaced meets the recommended specification listed in this document.

Note

Be careful not to touch the ribbon as you will get ink on your hands and
clothing. A pair of plastic gloves and a moist towelette are normally
included in each Hewlett-Packard ribbon package to help protect yourself
from the ink.

PREPARING THE PRINTER FOR OPERATION 3-1

This manual is related to the following products:

2567C