Sony DHC-MDX10 - Manual (Page 86)

Troubleshooting (continued) MD Deck
Speakers
Sound comes from one channel or
unbalanced left and right volume.
• Check the speaker connection and
speaker placement.
Sound lacks bass.
• Check that the speaker's + and - jacks are
connected correctly.
CD Player
The CD tray does not close.
• The CD is not placed properly.
The CD will not play.
• The CD is not lying flat in the disc tray.
• The CD is dirty.
• The CD is inserted label side down.
• Moisture condensation has built up.
Remove the CD and leave the system
turned on for about an hour until the
moisture evaporates.
Play does not start from the first track.
• The player is in program or shuffle mode.
Press PLAY MODE repeatedly until
"PROGRAM" or "SHUFFLE" disappears.
"OVER" is displayed.
• You have reached the end of the CD.
Press ◄◄ to return.
The display shows a code made up of
three letters and a message
• This system has the Self-Diagnostic
function (see "Self-diagnosis Display" on
page 88).______________________________
The disc will not be inserted.
• Insert the MD in the direction of the
arrow.
The controls do not work.
• The MD is dirty or scratched. Replace the
MD with a new one.
The MD will not play.
• Moisture condensation has built up.
Remove the MD and leave the system
turned on for several hours until the
moisture evaporates.
• Nothing is recorded on the MD.
Recording is not possible.
• The MD is protected against erasure.
("Cll" and "Protected" appear
alternately.) Slide the tab to close the slot
(see page 34).
• Connect the sound source properly.
• A pre-recorded MD is in the deck.
Replace the disc with a recordable MD.
• Replace the disc with a recordable MD
that-has sufficient time remaining or erase
unnecessary tracks.
• The mains lead was unplugged or a
power interruption occurred during
recording. Start recording over from the
beginning.
"-OVER-" is displayed.
• You have reached the end of the MD.
Press ◄◄ to return to the beginning of
the MD.
"OVER" lights up during recording.
• A strong signal was input during
recording in the TAPE function. When
the sound is distorted, reduce the
recording level ("Adjusting the recording
level" on page 42), then re-record.
86