Dell Latitude Xpi CD - Manual (Page 80)

4-42 Dell Latitude XPi CD Service Manual
I/O-Panel Dust Cover
Figure 4-30. I/O-Panel Dust Cover Removal
To remove the I/O-panel dust cover, follow these steps:
1. Remove the palmrest assembly.
2. Remove the display assembly.
3. Remove the superpart assembly.
4. Remove the system board.
5. Remove the I/O-panel dust cover.
Push outward on one end of the dust cover to release the pivot pin from its
associated pivot hole. Then repeat the operation for the other end of the
cover. After both ends have been disengaged, lift the dust cover away from
the system board assembly.
To replace the I/O-panel dust cover, orient the cover in its original position and
snap the pivot pins into place in their associated pivot holes. Make sure the dust
cover opens and closes freely before you reinstall the display assembly.
Part or Assembly Name Order Name
I/O-panel dust cover DOOR,PLSTC,I/O,LXP/NBK
I/O-panel
dust cover
pivot pin (2)
pivot hole (2)