Dell Latitude E6400 - Manual

Replacing the Bottom Access Panel
About Cautions
CAUTION:
A CAUTION indicates a potential for property damage, personal injury,
or death.
CAUTION:
Before you begin any of the procedures in this section, read the safety
information that shipped with your computer. For additional safety best practices
information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
NOTICE:
If you need to remove the computer cover, first disconnect the computer
power and modem cables from all electrical outlets.
To replace the bottom access panel of your computer, you need the
iAMT configuration-mode number that is located on the original bottom
access-panel of your computer.
Follow the instructions on this tech sheet carefully to ensure that you:
• Remove the original bottom access-panel from your computer (see your
Service Manual).
• Select the correct label that is provided in the replacement kit.
• Install the label in the correct location on the replacement bottom
access-panel.
To replace the bottom access panel:
1 Remove the original bottom access-panel from your computer (see your
Service Manual).
NOTE:
If the original iAMT configuration-mode label is missing, damaged,
or otherwise illegible, contact Dell to obtain your iAMT configuration-mode
number (see your Setup and Quick Reference Guide for contact information).
June 2008
T539H0am0-edited.fm Page 1 Tuesday, November 3, 2009 4:57 PM