Dell Open Manage Print Manager Software - Manual (Page 91)

Overview 91
NOTE: Depending on the model of the printer, certain parameters appear grayed-out on the widget, as shown in
the below Figure 5-10. These are the read-only parameters for that model.
Figure 5-10. SNMP Network Settings Window
Field Description
Port On Indicates the status to enable or disable the SNMP port on the device. This must be
turned on for OMPM to manage the printer.
Read Community Indicates the community name used by the printer for SNMP reads.
Write Community Indicates the community name used by the printer for SNMP writes.
Trap Community Indicates the community name used by the printer for sending traps.
Trap Notification On Indicates the status to enable or disable sending off traps by the printer.
Notification Address Indicates the address to which the SNMP traps are sent by the printer. It is normally an
IP or host name (determined by the printer).
Notification Port Indicates the port at the Notification Address where the printer sends SNMP traps.
Error Trap On Indicates the status to on or off the SNMP traps for the printer.