Dell PowerVault TL4000 - Manual (Page 211)

Chapter 10. Check, Adjust, Remove, and Replace
Tools Required
To service a library you may need one or more of the following tools:
v #2 Phillips screwdriver
v Ground strap (recommended, if available)
Electrostatic Discharge
Important: A discharge of static electricity can damage static-sensitive devices or
microcircuitry. Proper packaging and grounding techniques are
necessary precautions to prevent damage.
To prevent electrostatic damage, observe the following precautions:
v Transport products in static-safe containers such as conductive tubes, bags, or
boxes.
v Keep electrostatic-sensitive parts in their containers until they arrive at static-free
stations.
v Cover the unit with approved static-dissipating material. If available, provide a
ground strap connected to the work surface and properly grounded tools and
equipment. If a ground strap is not available, touch a metal surface to discharge
any static electricity in your body.
v Keep the work area free of no conducting materials, such as ordinary plastic
assembly aids and foam packing.
v Make sure you are always properly grounded when touching a static-sensitive
component or assembly.
v Avoid touching pins, leads, or circuitry.
v Use conductive field service tools.
Relocating Your Library
When moving or shipping your library, it is important that the shipping lock be in
place to prevent the accessor from moving and to protect the library from possible
damage. Before relocating your library, complete the following procedure.
1.
Remove all cartridges from inside the library.
2. Power OFF the library. This will align the robot with the shipping lock slot.
3. Remove any cables and terminators connected to the library.
4. Remove the library from the rack, if necessary.
5. Remove the shipping label ( 2 ) and lock ( 1 ) from the rear panel of the
library.
Figure 10-1. ESD label
10-1