Dell PowerVault TL4000 - Manual (Page 141)

Configure Library Menu
The Configure Library menu contains the following submenu items:
v “Configure Library: General”
v “Configure Library: Logical Libraries” on page 5-44
v “Configure Library: Path Failover” on page 5-45
v “Configure Library: Encryption” on page 5-46
v “Configure Library: Drives” on page 5-48
v “Configure Library: Network” on page 5-50
v “Configure Library: User Access” on page 5-52
v “Configure Library: Date & Time” on page 5-54
v “Configure Library: Logs & Traces” on page 5-54
v “Configure Library: Event Notification” on page 5-55
v “Configure Library: SNMP” on page 5-56
v “Configure Library: Save/Restore Configuration” on page 5-57
Configure Library: General
This page allows you to make changes to general library configuration elements.
As changes are made, they will only be applied after the Apply Selections or the
Submit
button is selected. After making the selection, a warning page will inform
you of the impact of the proposed change. In some cases a pop-up screen will ask
for confirmation. Many changes will also require a library reboot.
Table 5-10. Configure Library: General page elements
Menu Item Description 2U 4U
Library Name Enter the name of the library. X X
I/O Station
Enabled The I/O Station defaults to I/O Station Enabled. Choosing Disabled (no
checkmark) adds one more storage slot to the 2U library, and 3 more
storage slots to the 4U library. When the I/O Station is disabled,
removing or adding media to the library must be performed by releasing
the left and/or right magazine(s). X X
Auto Clean
Enabled Auto Clean defaults to Disabled. For Auto Clean to function, a cleaning
cartridge (CLNxxxLx) must be resident in a reserved library slot and
Auto Clean must be enabled (turned on).
Note:
If Auto Clean is enabled, and a cleaning cartridge is not resident in
a reserved slot, the Auto Clean Status field in the web System Status
screen will post a "Chk Media/Rsvd Slot" message.
X X
Bar Code Label
Length Reported
To Host The default bar code label length is 8, but can be set to 6. The bar code
label length is a "reported" length. This setting will cause the host
computer to only see the first 6 characters of the label or all 8 characters.
This setting does not affect the bar code label that is shown on any of the
library user interfaces (always shows all 8 characters). X X
Table 5-11. Configure Library: Specific page elements
Menu Item Description 2U 4U
Library Mode Choices are Random and Sequential. If you choose Sequential, you may
also activate Autoload and/or Loop. If there is more than one logical
library, there is a Library Mode entry for each logical library.
Important:
If a Logical Library in Sequential Mode contains more than
one drive, only the first drive in the Logical Library will be utilized.
X X
Chapter 5. Operations 5-43