Dell PowerVault TL4000 - Manual (Page 80)

One cartridge magazine cannot be assigned to two logical libraries. If you partition
a multi-drive library, each of the magazines must be assigned to a logical library
on a magazine boundary. The entire magazine must be part of one logical library
only.
Note: If you have a 2U library with two drives, you have the capability to have
two logical libraries.
In a fully populated 4U library with four half height drives and four logical
libraries, resource assignments will be as follows:
v Logical Library 1 will contain Drive 1 and the lower left cartridge magazine.
v Logical Library 2 will contain Drive 2 and the upper left cartridge magazine.
v Logical Library 3 will contain Drive 3 and the lower right cartridge magazine.
v Logical Library 4 will contain Drive 4 and the upper right cartridge magazine.
The I/O Station and slots reserved for cleaning cartridges, if any, are shared among
all logical libraries.
1.
Click Configure Library > Logical Libraries in the left navigation pane.
2. Select the number of logical libraries you would like to create in your library.
3. Click Submit to create the logical libraries.
Entering Path Failover Feature Activation Key
For more information, refer to the Dell PowerVault TL4000 Failover Configuration
Guide, included with the library documentation.
1.
Click Configure Library > Path Failover in the left navigation pane.
2. Enter the Control Path Failover 12-digit feature key in the spaces provided.
3. Click Activate to save the feature key. The following screen will display if you
have correctly entered the feature key.
a77ug09
8
Figure 4-26. The 4U library Configure Library: Logical Libraries page
a77ug
11
7
Figure 4-27. The Configure Library: Path Failover Feature Activation screen
4-26 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide