Dell PowerVault TL4000 User Manual
Page 83
v
Internal Label - Selective Encryption
: Check your tape backup software
application documentation to see if this feature is supported.
v
Internal Label - Encrypt All
: Check your tape backup software application
documentation to see if this feature is supported.
7.
A primary and secondary key management server can be set for each logical
library. Each partition has its own Encryption and key management settings.
Maintaining primary and secondary key management servers is desired for
maximum availability of encrypted backup and recovery. These settings are
required for Library Managed Encryption only. Enter the EKM Server Setting
information.
Note:
The IP address of the key management host must be consistent with the
library Network settings. This means if the library is set to IPV4 only
network support, the key management host must be an IPV4 address. If
the Dell PowerVault library is required to function in a mixed network
environment the library must be set to IPv4 + IPv6.
v
Primary IP address (IPv4 or IPv6)
: Enter the IP address of the primary key
management server.
v
Primary TCP port
: After entering the Primary IP address, the library will
automatically set the value of the Primary TCP port.
v
Secondary IP address (IPv4 or IPv6)
: Enter the IP address of the secondary
key management server.
v
Secondary TCP port
: After entering the Secondary IP address, the library
will automatically set the value of the Secondary TCP port.
Note:
The Default Port for TCP (SSL disabled) is 3801. The Default Port for
SSL is 443. These values are the default values set by the library. They
can be changed depending on the user configuration but the user has
to make sure they match the EKM properties file.
Note:
If SSL is enabled the encryption host configuration will request a SSL
port instead of a TCP port. Review your IBM SKLM Knowledge Center
online at for instructions to locate the appropriate
port settings.
8.
Click Submit to apply the changes.
9.
Install the IBM SKLM application on your host. Refer to the IBM SKLM
Knowledge Center online for information on locating the appropriate IP address
and port.
Choosing Drive(s) Interface Identification/Settings
1.
Click Configure Library > Drives in the left navigation pane.
Chapter 4. Installation and Configuration
4-29