Dell PowerVault TL4000 - Manual (Page 161)

v Drive Test: The library performs a drive communication test to confirm
communication with the drive.
v Ethernet Test: For each key management IP address, the library performs a ping
test and records the results.
v EKM Path Test: For each key management IP address that passed the ping test,
the library performs a communication test.
v EKM Config Test: This test confirms that a drive is correctly configured in the
key manager to service key requests.
To run the Key Path Diagnostic, complete the following procedure.
1.
Log on to the Web User Interface. Refer to “Login” on page 2-5.
2. Quiesce all drives, then unload all drives.
3. Click Service Library, then Key Path Diagnostics.
4. Click Start Tests.
Note: If you have just enabled encryption on your library, wait for all LME
drives to be displayed in the table and the Start Tests button to become
active.
Each test will show a result of "Passed" or "Failed". If a test fails the remaining
tests will not be executed, and the test will show a result of "N/A". The IP Address
may show "N/A" for the following reasons:
1.
Drive is not encryption capable.
2. EKM Server Settings, on the Configure Library > Encryption page, are not
configured correctly.
Test results will clear:
v When the test is rerun
v When the library is rebooted
The time and date of the last test will appear below the Key Path Diagnostics
screen. If any of the tests fail, refer to Chapter 7, “Troubleshooting,” on page 7-1 for
additional information.
Service Library: Upgrade Firmware
Consider these recommendations to provide maximum performance and reliability:
1.
The latest version of microcode must be installed on your Dell tape libraries
and devices.
a77ug
1
9
3
Figure 5-58. Service Library: Perform Key Path Diagnostics page
Chapter 5. Operations 5-63