Dell PowerVault TL4000 - Manual (Page 126)

Table 5-4. Factory Default Settings (continued)
Restored Item Default Setting* Comments
DHCP Enabled Note: DNS server addresses, if
available, will be automatically
assigned. If the DHCP server does
not find any DNS server, the DNS
fields will be set to "0.0.0.0".
Network IP Mode IPv4 Only
Bar Code Label Length Reported to
Host 8
SNMP Disabled
Email Notifications None
User Access Restore from Operator Control Panel
or Web User Interface
Admin secure (default)
Library Mode Random
Library Name (Blank)
Host Name (Depends on MAC Address)
Logs & Traces Error Log Mode Continuous
Path Failover Key No change License Key is protected, if
previously entered.
OCP Access PIN Disabled
Note:
The initial Factory Default
setting is disabled. If the OCP Access
PIN setting is changed, executing
"Restore Defaults" will not change the
setting.
If OCP Access PIN has been enabled
the default PIN is "1234".
SSL for Web Disabled
Drives
Power Power On (All drives)
Drive 1 SCSI-ID 4 SCSI Drives
Drive 2 SCSI-ID 5 SCSI Drives
Drive 3 SCSI-ID 6 SCSI Drives
Drive 4 SCSI-ID 8 SCSI Drives
Drive 1 Loop-ID 4 FC Drives Arbitrated Loop
Drive 2 Loop-ID 5 FC Drives Arbitrated Loop
Control Path Drive Drive 1 only
Partitions None
Reserved Slots 2U:24, 4U:48
IPv6 Stateless Autoconfig Enabled
Note : * = all settings at library firmware level 4.xx and greater
In some cases, (such as Library Mode), the entry of one option precludes any other
options from being selected. In such cases, the details of the non-applicable options
are not shown.
5-28 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide