Cabletron Systems CSMIM-T1 - Manual (Page 93)

BOOT Failures
CSMIM-T1 Hardware Installation Guide 5-9
Activity TE2: Hardware Failure
The ROM diagnostics detected a CSMIM-T1 hardware problem requiring
service. Call Technical Support.
Activity TE7: Booted Wrong Image
The CSMIM-T1 loaded an inappropriate image. Press the SETUP button
for three seconds to reset the device. Following is a list of ways to prevent
this problem in the future:
• Be sure that you configure the CSMIM-T1 with the appropriate image
(
oper.46.enet ).
• Be sure that the image you are booting has the right name. Don’t
rename the image file unless you are making a copy for safe keeping.
• If you used an na, admin, or cli boot command, specify the correct
image and a valid filename.
5.3 BOOT FAILURES
The procedures for troubleshooting a power-up failure established that
• The hardware is functional.
• The Ethernet interface is functional.
• The CSMIM-T1 can communicate with the Ethernet.
If the CSMIM-T1 still is not booted, you must pinpoint the problem. The
boot error report can help in this process.
Generally, two problems cause boot failures:
• The CSMIM-T1 is not configured properly.
• The load server host is not responding.
NOTE
The CSMIM-T1generates a boot error report only if it opens the
boot file and an error occurs during the boot process.