Cabletron Systems CSMIM-T1 - Manual (Page 56)

Chapter 3: ROM Monitor Commands
3-14 CSMIM-T1 Hardware Installation Guide
If the self-boot option is not installed, the command display looks
like this:
3.2.6 help
Entering help, or ?, displays brief descriptions of the CSMIM-T1 ROM
Monitor commands.
3.2.7 image
The image command sets and displays the name of the image file
containing the CSMIM-T1’s software. The command syntax is:
image [–d | filename]
The filename argument permits up to 100 characters. To return the image
name to its default, enter a pair of double-quote characters (""). The
default image name is oper.56.enet. The image command display looks
like this:
NOTE
The erase command does not erase the Ethernet address.
Since the erase command erases the IP address, you must
use the addr command to re-enter the CSMIM-T1’s IP address
before reloading any software.
monitor:: erase
Erase all non-volatile EEPROM memory? (y/n) [n]:: y
Erasing <16352 or 8160 bytes> of non-volatile memory.
Please wait . . .
16K->|Data 0xff
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
16K->|Data 0x0
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Initialized checksum record installed
monitor:: image
Enter Image name: [(ip) "oper.56.enet", (mop)
"OPER_56_ENET.SYS"]::
Enter TFTP Load Directory [""]::
Enter TFTP Dump path/filename ["dump.192.9.200.88"]::