Cabletron Systems CSMIM-T1 - Manual (Page 70)

Chapter 4: CSMIM-T1 Parameters
4-2 CSMIM-T1 Hardware Installation Guide
stats -T
The stats -T command displays T-1 network interface statistics for the
Annex. Table 4-2
describes the arguments for stats -T. The syntax is:
stats -T [ current | total | all | interval_set | clear_alarm ]
Table 4-2 Arguments for the stats -T Command
The stats -T current command display looks like this:
Argument Description
current Displays Extended Super Frame (ESF) statistics for the
current fifteen minute interval. The tni_framing parameter
must be set to
esf (default). If the tni_framing parameter is
set to d4, the current statistics are not displayed.
total Displays the total number of ESF statistics collected.
all Displays all ESF statistics.
interval _set Displays a specific ESF interval. You can enter a single
interval or a range of intervals from 1 to 96. Interval 1 is the
most recent interval.
clear_alarm Clears the alarm condition saved in the history buffer.
annex# stats -T current
alarm history: [ no blue no red no yellow ], Fri July 28 16:48:37 1995 EDT
Alarms:
no blue no red
no yellow
engine: offline no sync no D&I sync
no loss of signal
serial number: 08
circuit ID:
T1 info:
unit ID: XYLOGICS T1-ENGINE 085234 Rev. A 07/19/95 6343
loopback mode: No loopback
uptime: 69:07:49
Current Statistics
number of valid seconds: 469
bursty errored seconds (ESF only):0 Controlled slip seconds:0
errored seconds: 0 Severly errored seconds:0
unavailable seconds: 0
out of frame errors: 0 bipolar violations: 0
CRC errors (ESF only): 0 controlled slilps: 0
received net alarms: 0
annex#