Cabletron Systems CSMIM-T1 User Manual
Page 179
Registers
CSMIM-T1 Hardware Installation Guide
7-53
:T7=
n
Timer for False Answer Abort
Where n is an integer from 0 to 255, representing seconds.
Default n=60 seconds; setting :T7=0 disables this timer.
This command takes effect only when the modem falls back to
a normal mode V.23 half-duplex connection.
Sets the amount of time the modem waits before hanging up
when it receives no data. If this command is set to a value
greater than zero, the timer starts when the modem connects. If
the modem does not receive data in the specified time, it hangs
up.
:T9=
n
Primary XON Flow Control Character
Where n is a decimal from 0 to 255, representing an 8-bit
character. Default n=11 hexadecimal (or 17 decimal)
Defines the character used for primary XON flow control on the
modem and serial ports. Enable primary flow control with \Q1,
\Q4, \G1, or \G2.
:T10=
n
Primary XOFF Flow Control Character
Where n is a decimal from 0 to 255, representing an 8-bit
character. Default is 13 hexadecimal (or 19 decimal)
Defines the character used for primary XOFF flow control on
the modem and serial ports. Enable primary flow control with
\Q1, \Q4, \G1, or \G2.
NOTE
With modem-port flow control, both modems must have the
same primary flow control characters set during normal
connections.