Cabletron Systems CSMIM-T1 User Manual
Page 133
Commands
CSMIM-T1 Hardware Installation Guide
7-7
D
Where
< or >.Valid dial string characters are: 0-9, dial modifiers, and for
tone dialing A, B, C, D, #, and*. The modem ignores invalid
characters. Dial strings longer than 98 characters produce an error
message.
Dials a telephone number and attempts to establish a connection.
The Dial command must be the last one on a command line.
To cancel the Dial command, press any key or use your data
communications software to lower DTR (unless &D0 is set).
To dial the telephone number 011 22 555 1234, type:
ATD 011225551234
Dial Modifiers
Dial modifiers allow you to add conditions to the telephone
number you dial. You can use several modifiers with the same
telephone number. Dial modifiers include:
^A
(Link Negotiation) Perform link negotiation at 4,800 bps for the
current connection only. (This dial modifier is equivalent to the
*H2 command.)
J
(Link Negotiation) Perform link negotiation at 1,200 bps for the
current connection only. (This dial modifier is equivalent to the
*H1 command.)
K
(Cell-Side Cellular Connection) Sets )M1 for the current
connection only.
P
(Pulse Dial) Placed anywhere in the dial string, causes the modem
to pulse dial. For example: ATD P5551234
NOTE
After disconnect, there is a 5-second delay before the modem
goes off hook in originate mode.