Cabletron Systems CSMIM-T1 - Manual (Page 169)

Registers
CSMIM-T1 Hardware Installation Guide 7-43
S4= n Line Feed Character
Range: 0 - 127, ASCII decimal
Default: 10 (line feed)
Sets the character recognized as a line feed. The line feed
character follows the carriage return at the end of command
lines and result codes.
The modem does not store this register with &W; enter *W to save it.
S5= n Backspace Character
Range: 0 - 32, ASCII decimal
Default: 8 (backspace)
Sets the character recognized as a backspace.
The modem does not store this register with &W; enter *W to save it.
S6= n Wait Before Dialing
Range: 2 - 255 seconds
Default: 2 seconds
Sets the length pause after off hook before the modem dials. The
modem always pauses for a minimum of two seconds, even if
S6 is set less than 2.
S7= n Wait for Carrier After Dial
Range: 0 - 255 seconds
Default: 60 seconds
Sets the length of time that the modem waits for
• Carrier from remote modem before hanging up (originate or
answer mode).
• Ring back (originate mode only, and only if either X3 or X4 is
set).
• Dial tone when the “W” dial modifier is encountered in a dial
string.
NOTE
Register S6 is valid only when either X0, X1, or X3 is set.
The modem does not store this register with &W; enter *W to
save it.