Cabletron Systems CSMIM-T1 - Manual (Page 69)

CSMIM-T1 Hardware Installation Guide 4-1
CHAPTER 4
CSMIM-T1 PARAMETERS
4.1 GENERAL
The CSMIM-T1 comes with software that supports specific commands
and parameters for the configuration and administration of the
CSMIM-T1 module. These commands cannot be accessed through the
console port. You must either telnet into the CSMIM-T1 from another IP
address, or you may use the NA utility. Also note that these commands are
not available until after the unit has successfully booted. The following
sections describe the commands and parameters, and Section 4.5 provides
an example of how to use them.
4.2 T-1 COMMANDS
The CSMIM-T1 software comes with the following new or enhanced
commands:
Table 4-1 T1-related Commands
Command Command Type Description
stats -T CLI Displays T-1 Network Interface
statistics.
show admin / na Shows a T-1 configuration parameter.
set admin / na Sets a T-1 configuration parameter.
reset admin / na Resets the T-1 engine and ESF
statistics.
t1_loopback Superuser CLI Places the T-1 engine into loopback
mode.