Cabletron Systems CSMIM-T1 - Manual (Page 11)

Table of Contents
CSMIM-T1 Hardware Installation Guide xi
5.3.1 Boot Error Report.......................................................... 5-10
5.3.2 Correcting CSMIM-T1 Parameters ............................... 5-13
5.3.2.1 Load Server Host Not Responding............... 5-14
5.3.2.2 UNIX Host on the LAN ................................. 5-14
5.3.2.3 Another CSMIM-T1 ...................................... 5-15
5.3.2.4 VAX VMS Load Host on the LAN ................. 5-16
5.4 CSMIM-T1 Dumps.................................................................... 5-17
CHAPTER 6 MODEM GUIDE
6.1 General........................................................................................ 6-1
6.2 Features ...................................................................................... 6-2
6.3 Using the AT Command Set........................................................ 6-3
6.3.1
Key AT Command Factory Defaults ............................... 6-4
6.3.2 Establishing 11-Bit Data Connections ............................ 6-5
6.3.3 V.32bis Cellular Connections Using AT Commands ...... 6-6
6.3.3.1 Universal Cellular Setup ................................. 6-6
6.3.3.2 MNP 10 V.32bis Quick Connect Cellular Only
Setup6-6
6.4 Modulation Protocols ................................................................... 6-7
6.4.1
Protocol Configuration Command Settings................... 6-10
6.4.2 Speed and Protocol Connection Matrices .................... 6-11
6.5 Error Correction ......................................................................... 6-14
6.6 Diagnostics ................................................................................ 6-16
6.6.1
Power-Up Diagnostics .................................................. 6-16
6.6.2 Local Analog Loopback with Self-Test.......................... 6-16
6.6.3 Local Analog Loopback ................................................ 6-17
6.6.4 Remote Digital Loopback with Self-Test ....................... 6-17
6.6.5 Remote Digital Loopback.............................................. 6-18
6.6.6 Local Digital Loopback.................................................. 6-18
6.6.7 Respond to Remote Digital Loopback .......................... 6-19
6.6.8 Automatically Terminating a Test: Register S18........... 6-19
6.7 Result Codes ............................................................................. 6-20
6.7.1
Connection Result Code Tables ................................... 6-20
CHAPTER 7 AT COMMANDS AND REGISTERS
7.1 The Command Set ...................................................................... 7-1
7.1.1
Entering Commands ....................................................... 7-1
7.1.1.1 Issuing AT Commands at any Speed............. 7-2
7.2 Commands .................................................................................. 7-2
7.2.1
Operating Mode Dial Modifiers ....................................... 7-9
7.3 Registers ................................................................................... 7-41
7.3.1
Commands to Change or Read Registers .................... 7-41