Cabletron Systems CSMIM-T1 - Manual (Page 64)

Chapter 3: ROM Monitor Commands
3-22 CSMIM-T1 Hardware Installation Guide
If you enter the command with the –d argument, the console displays the
current load/dump interface list. You cannot specify both the –d argument
and the interface list with the same command. The sequence –d
command display looks like this:
Entering a number for a port that has not been configured properly for
SLIP causes the Port nn is not configured for SL/IP message to display,
where nn is the port number.
3.2.16 slip
The slip command defines a serial port as a Serial Line Internet Protocol
(SLIP) interface. This command defines a number of port parameters.
The command syntax is:
slip [–d] [port]
After entering the command, you are prompted for each parameter. The
port is the number of the serial port to be configured with this command.
If you do not enter a port number, you will be prompted for one. Table
3-2
lists the information for which the slip command prompts.
Entering slip –d causes the command to display all the current settings.
NOTE
The CSMIM-T1 can slip boot over any port except Port 1.
monitor:: sequence -d
Interface sequence: sl12,net