Index – Cabletron Systems CSMIM-T1 User Manual
Page 189
CSMIM-T1 Hardware Installation Guide
INDEX-1
Symbols
$B to change serial-port speeds 6-3
$D and diagnostics 6-16
%G and protocol settings 6-10
( 7-50
*H and cellular connections 6-6
+++ to enter command state 6-5
Numerics
10-bit data characters 7-13
10-bit data command 7-13
11-bit data characters 6-2, 7-13
11-bit data command 7-13
11-bit data connections 6-5
2-second billing delay 7-57
Self-booting without
a Local Ethernet Interface 2-15
A
ACE features 6-1
ACE overview 6-14
adaptive packet assembly 6-15
addr command 3-3
advanced channel enhancements 6-1
Adverse Channel Enhancements
alternative B V.22 6-9
analog lookback register 7-47
analog loopback
local 6-17, 7-34
with self-test 6-16, 7-34
analog test commands 7-33
answer interval 7-43
answer command 7-2
answer mode dial modifier 7-8
answer mode register 7-45
answer tone length register 7-57
answer tone register 7-50
answer tone timer 7-51
asynchronous mode register 7-50
asynchronous/synchronous time
T2 and auto-answer 6-7
AT commands, introduction 6-3
AT$B to change
AT$D and diagnostics 6-16
AT%G and protocol setting 6-10
AT&T BELLCORE calling card
AT*H and cellular connections 6-6
AT-E and 11-bit connections 6-5
ATH to hang up 6-5
attention sequence guard time 7-45
auto-answer and T2 6-7
auto-answer register 7-42
automatic fallback 7-20
automatic speed matching 7-20
auto-reliable mode 7-10, 7-26
auto-reliable buffer command 7-6
auto-reliable fallback character 7-3
auto-reliable mode dial modifier 7-10
auto-reliable mode, set 7-25
auto-retrain command 7-13
B
backspace character 7-43
Backspace key 7-1
Bell 103 connect messages 6-10
Bell 103 overview 6-10
Bell 212A 7-48
Bell 212A overview 6-9
Bell/ITU-T command 7-3
BELLCORE bong
INDEX