Cabletron Systems CSMIM-T1 - Manual (Page 106)

Chapter 6: Modem Guide
6-4 CSMIM-T1 Hardware Installation Guide
6.3.1 Key AT Command Factory Defaults
Table 6-1 Key AT Command Factory Defaults
AT Title Default
$B n Serial-Port Bps Rate 115,200
%B n Modem-Port Bps Rate 28,800
%C n Compression Control 3 (MNP 5 & V.42bis)
&C n Serial-Port DCD Control 1 (On after connect message)
D Dial T (Tone dial)
&D n DTR Control 2
E n Command Echo 1 (echo to local DTE)
&F Restore Factory Defaults none
H Hang Up none
*H n Link Negotiation Speed 0 (at highest speed)
\J n Bps Rate Adjust 0 (disabled)
%L n Speed Matching 1 (enabled)
)M n Cellular Power Level Adjustment 0 (For central site modems)
@M n Select Cellular Transmit Level 0 (-26 dBm)
\N n Operating Mode 3 (auto-reliable)
O n Enter Connect State and Retrain none
Q n Quiet 0 (result code output)
\Q n Serial-Port Flow Control 3 (bi-directional hardware)
%R n Read All Registers none
S n? Read Configuration Register none
\S Read On-line Status none
T Tone Dial none
:T n? Read Configuration Register none