Cabletron Systems CSMIM-T1 User Manual

Page 36

Chapter 2: INSTALLING THE CSMIM-T1

2-10

CSMIM-T1 Hardware Installation Guide

At the monitor prompt on the console, type config and press the
Return key. The following appears on the screen:

REVISION/CONFIGURATION INFORMATION

ROM Software Rev: 0914
Board ID: 42

Board Type: CSMIM-T1

CPU Type: 486SXLC2

Ethernet Address: 00-80-2D-00-18-B6

Memory size: 4 Meg

EEPROM size: 65504

Flash size: N/A

Flash ID: N/A

T1 Unit Identification: XYLOGICS T1-ENGINE 085234 Rev. A 07/19/95 6343
T1 Network Jumper: Cross Connect Mode
DS0: B8ZS Coding

ESF Framing

AT&T FDL Format

DSX: B8ZS Coding

ESF Framing

Line Distance=535 to 635 Feet

Port #

.....

T1 Slot Map

.....

Mod ID

288X

.....

288X

Mod Status

.....

Port #

.....

T1 Slot Map

.....

Mod ID

288X

.....

288X

Mod Status

.....

To record the CSMIM-T1’s Ethernet address for future reference: at the
monitor prompt, type addr -d and press the Return key. The display
looks like this:

monitor::

addr -d

Ethernet address (hex): 00-80-2D-00-18-B6
Internet address:
Subnet mask: 255.0.0.0
Broadcast address: 0.0.0.0
Preferred load host address:
Preferred dump address: 0.0.0.0
Load/Dump Gateway address:
Type of IP packet encapsulation:
Load broadcast: Y

NOTE

You are prompted for the gateway address only if the Internet
address differs from the preferred Load Host address based on
the Subnet Mask. If these addresses are the same, the
CSMIM-T1 assumes there is no gateway.