Cabletron Systems CSMIM-T1 - Manual (Page 73)

T-1 Commands
CSMIM-T1 Hardware Installation Guide 4-5
show t1
The show t1 command displays current T-1 configuration parameters:
The syntax is:
show t1 t1_parameter
set t1
The set t1 command requires superuser privileges, and modifies
CSMIM-T1 configuration parameters.
The syntax is:
set t1 t1_parameters
reset
The reset command requires superuser privileges. A reset terminates any
active connections.
The reset t1 command resets the T-1 engine and the extended super
framing (ESF) statistics. This command is used to change the T-1 engine’s
parameter configuration. The T-1 soft, hard, and esf keywords are
described in Table 4-4
. The syntax is:
reset t1 [soft | hard | esf]
Errored
Seconds An Errored Second is a second with one or more ESF error
events; that is, one or more CRC error events or one or more
Out of Frame (OOFs).
Severely
Errored
Seconds A Severely Errored Second (SES) is a second with 320 or
more CRC error events or one or more OOF error events.
Unavailable
Seconds Unavailable Seconds (UAS) are a count of one-second
intervals during which service is unavailable.
Table 4-3 stats-T Command Information
Field Description