Canon mp280 - Manual (Page 68)

Advanced Guide Troubleshooting
Contents > Routine Maintenance > Cleaning the Machine > Cleaning the Paper Feed Roller
C099
Cleaning the Paper Feed Roller
If the Paper Feed Roller is dirty or paper powder is attached to it, paper may not be fed properly.
In this case, clean the Paper Feed Roller. Cleaning will wear out the Paper Feed Roller, so perform this
only when necessary.
You need to prepare: three sheets of A4 or Letter-sized plain paper
1.
Make sure that the power is turned on, and remove any paper from the Rear Tray.
2.
Open the Paper Output Tray gently, and open the Output Tray Extension.
3.
Clean the Paper Feed Roller without paper.
(1) Press the (Maintenance) button repeatedly until b appears.
(2) Press the Black or Color button.
The Paper Feed Roller will rotate as it is cleaned.
4.
Clean the Paper Feed Roller with paper.
(1) Make sure that the Paper Feed Roller has stopped rotating, and load three
sheets of A4 or Letter-sized plain paper in the Rear Tray.
(2) Make sure that b appears on the LED, then press the Black or Color button.
The machine starts cleaning. The cleaning will be completed after the paper is ejected.
Note
After the cleaning is completed, press the Stop/Reset button to return the LED to the copy
standby mode.
If the problem is not resolved after cleaning the Paper Feed Roller, contact the service center.
Page top
Page 68 of 707 pages Cleaning the Paper Feed Roller