Canon mp280 - Manual (Page 21)

Advanced Guide Troubleshooting
Contents > Scanning > Saving Scanned Data on the Computer
C041
Saving Scanned Data on the Computer
This section describes the procedure to scan originals using the Operation Panel on the machine and
save them on the computer, according to the settings specified with MP Navigator EX.
For operations to scan originals from the computer, refer to the on-screen manual:
Advanced Guide .
Important
Please note that Canon shall not be liable for any damage or loss of the data for any reason
whatsoever, even within the warranty period of the machine.
Preparing for Scanning with the Operation Panel
Before scanning originals, check the following.
Are the necessary software applications (MP Drivers and MP Navigator EX) installed?
Install MP Drivers and MP Navigator EX from the Setup CD-ROM when they have not been installed
or have been uninstalled. To install MP Drivers and MP Navigator EX, select MP Drivers and MP
Navigator EX in Custom Install.
Are the settings for saving scanned data specified with MP Navigator EX?
When you save scanned data on the computer using the Operation Panel, you can specify the
settings for saving scanned data in Preferences of MP Navigator EX.
For details on the settings, refer to the on-screen manual:
Advanced Guide .
Does the original to be scanned meet the requirements for the original to be loaded on the Platen
Glass?
For details, see Originals You Can Load .
Is the machine connected to a computer correctly?
Confirm that the connection between the machine and the computer is physically secure.
Saving Scanned Data on the Computer
1.
Prepare for scanning.
(1) Turn on the power.
See Operation Panel .
(2) Load an original on the Platen Glass.
See Loading Originals .
Note
Characters and lines written with a light colored pen or highlight pen may not be scanned
properly.
2.
Press the SCAN button to start scanning.
MP Navigator EX will be started, and the scanned data will be saved on the computer according to the settings
specified with MP Navigator EX.
Remove the original on the Platen Glass after scanning is completed.
Important
Do not turn off the power while the machine is operating.
Do not plug in or unplug the USB cable while the machine is scanning originals.
Do not open the Document Cover or move the loaded original until scanning is completed.
Note
The position or size of the original may not be scanned correctly depending on the type of
Page 21 of 707 pages Saving Scanned Data on the Computer