John Deere stx38 - Manual (Page 295)

3/21/97
8 - 9
MISCELLANEOUS MOWER DECKS
LIFT LINKAGE REPAIR—
STX30 &
STX38 (SN —210000)
Adjustment
Left Bracket Half
Spacer
Ratchet
Lift Assist Spring
Cap
Cotter Pin
Lift Handle
Latch Handle
Latch
Latch Spring
Bolt
M52014
Screw
NOTE: The STX38 uses a heavier assist spring,
connected to a carriage bolt in a more
rearward position than on the STX30.
Disassemble
1. Remove battery and mower.
2. Remove cap screws. Remove handle.
3. Remove cotter pins, washers, and springs.
4. Remove handle from latch.
5. Remove cap screws.
6. Remove cap screws and spacers from bracket
halves.
7. Remove left and right bracket halves from tractor.
8. Remove latch and springs from bracket half.
9. Remove bolt, roller, and spacer.
10. Inspect and repair or replace parts.
Assemble
1. Install bolt, roller, and spacer.
2. Install latch and springs from bracket half.
3. Install left and right bracket halves from tractor.
4. Install cap screws and spacers from bracket halves.
5. Install cap screws.
6. Install handle in latch.
7. Install washers, springs, and cotter pins.
8. Install handle using cap screws.
NOTE: Adjust ratchet using slotted holes, for smooth
engagement with latch.
9. Install and adjust mower.
10. Install battery.