Cooper Instruments & Systems DFI INFINITY Digital Force Indicator/Controller - Manual (Page 76)

Table 11.29. Block B for “G” or “P” Commands For Batch or Square-root Modes
ITEM (HEX)
SUFFIX
DESCRIPTION BYTE NO. &
ORDER
25 Serial delay 1
24 Recognition character 2
23 Input offset 3, 4, 5
22 Input scale 6, 7, 8
21 Scale operator 9
20 Pulsed alarm number 10
1E Serial time 11, 12
1D Serial address 13
1C Bus format 14
1B Data format 15
17 Pulsed alarm time 16, 17
b) Command Prefix: “R” or “W”. It consists of 15 items, 25 bytes (50 ASCII characters) as shown in Table
11.30:
Table 11.30. Block B for “R” or “W” Commands For Batch Meter or Square-root Modes
ITEM (HEX)
SUFFIX
DESCRIPTION BYTE NO. &
ORDER
27 Output offset 1, 2, 3
26 Output scale 4, 5, 6
25 Serial delay 7
24 Recognition character 8
23 Input offset 9, 10, 11
22 Input scale 12, 13, 14
21 Scale operator 15
20 Pulsed alarm number 16
1E Serial time 17, 18
1D Serial address 19
format 20
1B Data format 21
1A Serial configuration 22
19 Baud rate 23
17 Pulsed alarm time 24, 25
1C Bus
11.32.3 Block B For Rate Meter
Block B has different data length depending on the Prefix Command.
a) Command Prefix: “G” or “P”. It consists of 12 items, 18 bytes (36 ASCII characters) as shown in Table 11.31:
Table 11.31. Block B For “G” or “P” Commands For the Rate Mode
ITEM (HEX)
SUFFIX
DESCRIPTION BYTE NO. &
ORDER
25 Serial delay 1
Recognition character 2
23 Input offset 3, 4, 5
22 Input scale 6, 7, 8
21 Scale operator 9
20 Pulsed alarm number 10
Serial time 11, 12
1D Serial address 13
1C Bus format 14
1B Data format 15
18 Gate time
Pulsed alarm time 17, 18
24
1E
16
17
CF 125 INFINITY SC GUIDE 72 M1519/N/0605