ClearOne Converge Pro - Manual (Page 240)

236 Technical Services: 800-283-5936
pUshToTalK – Push to Talk
This command selects/reports the setting of push-to-talk for a microphone.
Command Form : DEVICE pUshToTalK [Value]
argument Type size values Units
Channel Channel 1 See Groups and channels
Group Group 1 3 (m)
Value unsigned integer 2 0 = off
1 = on
2 = Toggle
(null to query in text)
Ramp – Ramp Gain Adjustment
This command starts / stops the gain ramp for an input, output or assignable processing block. There is no query
associated with this command.
Command Form : DEVICE Ramp [Target]
argument Type size values Units
Channel Channel 1 See Groups and channels
Group Group 1 1, 2, 3, 5, 7, 12, 16, 17 (i, o, m, p, l, F, T, r)
rate Signed integer 1 -50 – 50
if value=0, the ramp will stop.
if value< 0, the gain will ramp down.
if value>0, the gain will ramp up. dB / s
Target Signed integer 1 -65 – 20
if null in text or 0x80 in binary, the ramp will use
the channel’s maximum and minimum for a target. dB
Redial – Redial the Last Number
This command redials the last number. There is no query for this command.
Command Form : DEVICE Redial
argument Type size values Units
Channel Channel 1 See Groups and channels
Group Group 1 17 (r)
reserved 2 0
ReFsel – Reference Select for PA Adaptation & AEC
This command selects/reports which output or expansion bus reference is used for a mic input as a reference for
power amp adaptation mode and acoustic echo cancellation where applicable.
Command Form : DEVICE ReFsel [ref. Group ref. Channel]
argument Type size values Units
Channel Channel 1 See 3 (m) in Groups and channels
Group Group 1 3 (m)
reference Group Group 1 2, 8, 20 (o, A, B)
reference Channel Channel 1 See Groups and channels
(null to query in text)
ReFseT – Reference Channel Set Up
This command selects/reports the output the reference channel tracks.
Command Form : DEVICE ReFseT [reference output]
argument Type size values Units
Channel Channel 1 See Groups and channels