Tweco Ultra-Cut Torch Data - Manual (Page 88)

TORCH DATA for Ultra-Cut 8-88 Manual 0-4828 Rev BA
New Cartridge Assembly 400 Amp (21-1300) Consumables
9-9512
Speedlok Retaining Ring
9-9511
Thread Ring
Cartridge Body
Not Sold Seperately 9-7917
Outer Cartridge, 400A
9-9431
Tool, Torchhead, XT
Art # A-10925
Assembly Procedure
400A Cartridge is assembled in the following steps:
1. Insert the cartridge body into the speedlok retaining ring (9-9512). Note the orientation of the brass buttons/
pins.
2. Insert the above two parts into the thread ring (9-9511), which includes a set screw, making sure to align
the four tabs with the slots in the Cartridge Body.
3. Thread the Outer Cartridge (9-7917) onto the Cartridge Body and tighten using the Torchhead Tool (9-9431).
4. Use 1.3mm Allen Wrench/hex key to insert and secure the M2.5x3mm Cup Point set screw in a clockwise
direction.
8.11 Torch Consumables Installation
Art # A-03887
WARNINGS
Do not install consumables into the Cartridge
while the Cartridge is attached to the Torch Head.
Keep foreign materials out of the consumables and Cartridge.
Handle all parts carefully to avoid damage,
which may affect torch performance.