Metrohm 714 IC Metrodata - Manual (Page 9)

2.1 Hardware installation
IC Metrodata for Win95
3
Installation of 2 nd PC Board (1.714.0310)
1) Switch off PC and disconnect power cable from power socket.
2) Disconnect all other cables to computer peripherals (keyboard,
display, printer, etc.).
3) Change jumper settings on board 2: only jumper at position 6
must be installed.
4
5
6
8
4) Disassemble PC and install 1.714.0310 PC Board in a free slot
(see instruction manual of the PC).
5) Reassemble PC.
Installation of the 6.2145.010 Dongle
1) PC with 1 LPT port
Install 6.2145.010 Dongle into the LPT1 printer port. Insert printer
cable into the dongle.
2) PC with 2 LPT ports
Install 6.2145.010 Dongle into the LPT2 printer port. Insert printer
cable into the LPT1 printer port.
Check PC
1) Plug in all cables of the peripheral units at the PC.
2) Connect power cable to the power socket.
3) Switch on PC.
4) Check if the PC boots normally and all PC components and pe-
ripherals run properly.
5) Switch off PC.