Metrohm 714 IC Metrodata User Manual

Page 61

3.9 Manual remote control

IC Metrodata for Win95

Write, send and activate a program

•

Select

Equipment setup

of the

Options

menu.

•

In the

Configured equipment control drivers

window, click on

732 IC

Detector[ COM# ]

and afterwards on

Setup

. The

INITIAL

tab in the

732

IC Detector[ COM# ]

window is opened.

•

First open the

Program

tab, then open the

Text

tab. Click the

Add

button to add a new program line.

•

Enter the time

x.x

in min into the first field of the program line.

•

Select the desired program point in the second field (examples see

section 3.8).

•

Select the parameter belonging to the program point in the third

field. For

Flow

Pmax

and

Pmin

values must be entered, for

Remote

must be entered. A certain remote line position can be

changed by moving the cursor in front of this position and then en-

tering

•

Click the

Add

button to add new program lines or click the

Delete

button to delete program lines. Faulty program points are dis-

played in the lower part of the program field.

•

If you wish to use predefined remote instructions, open the

Remote

configuration

tab.

•

Click the

Add

button to add a new remote instruction.

•

Enter any name you like for the remote instruction (max. 19 charac-

ters, e.g.

Ext. Valve Fill

) in the first field.

•

Enter

for the corresponding remote instruction for remote

control lines 1...8 in the second field. A certain remote line position

can be changed by moving the cursor in front of this position and

then entering

•

Click the

Add

button to add more remote instructions or click the

Delete

button to delete remote instructions.

•

Click the

Activate

button. The entered remote instruction are added

to the standard program points and can also be selected.

•

Open the

Text

tab and add the predefined remote instructions into

the time program.

•

After finishing the programming, click the

Apply

button. The pro-

gram and the parameters are tested for consistency.

•

Switch on the

ENABLED

option.

•

Open the

Initial

tab.

•

Click on

. The parameters and the time program are now sent to

the 732 IC Detector.

in the lower left part of the window shows

that the PC is sending data. The time program is stored in the 732

IC Detector as program type

cycle

with

number of cycles = 1.

Manual triggering of actions via PC