Metrohm 714 IC Metrodata User Manual

Page 58

3 Learning by doing

IC Metrodata for Win95

togram. Therefore, program and parameters can be changed dur-

ing a running method, but the changes are not effective until the

next data acquisition.

Stop a running program
During the program run (green LED in the key of the 732 IC

Detector is blinking) the key is blocked. A running program

can be stopped as follows:

•

Stop data acquisition, reject chromatogram,

stop and restart program

Click on

or select

Acquire / Suspend chromatogram

to stop data

acquisition.
Click on

or select

Acquire / Restart method

. Confirm the ques-

tion

Available data will be lost. Continue?

with

Yes

. The

Start Run

win-

dow appears. Send the program to the 732 IC Detector by clicking

•

Stop data acquisition, save chromatogram, stop program

Close the data acquisition window. Confirm the question

Data aqui-

sition is activ! Standby?

with

Yes

. If the chromatogram should be

saved, confirm the question

01.run not saved. Save?

with

Yes

. Also

confirm the question

Method x modified. Save changes?

with

Yes

•

Stop data acquisition, save chromatogram,

continue program

Click on

or select

Acquire / Finish chromatogram

to stop the

data acquisition. The program continues until the

End

flag is set.

If a

Restart method

is set before the program at the 732 IC Detector

has been finished, the following messages appear:

•

Can’t use 732 IC Detector while time program running!

Confirm this

message with

•

Detection of hardware failed on

732

IC Detector

. The program at the

732 IC Detector is stopped. This is shown in the upper left part of

the field with

TempStop

. Restart the program with

Acquire / Restart

method