Metrohm 714 IC Metrodata - Manual (Page 62)

3 Bedienungslehrgang
IC Metrodata for Win95
56
• Select Equipment setup of the Options menu.
• In the Configured equipment control drivers window, click on 732 IC
Detector[ COM# ] and afterwards on Setup . The INITIAL tab in the 732
IC Detector[ COM# ] window is opened.
• Open the Manual Control tab.
•
Program RUN/STOP : The program at the 732 IC Detector is
started or stopped.
•
Valve A FILL/INJECT : Valve A at the 733 IC Separation Center is
switched to the Fill or Inject position.
•
Valve B FILL/INJECT : Valve B at the 733 IC Separation Center is
switched to the Fill or Inject position (only
possible with the 733.0020 IC Separation
Center).
•
Suppressor STEP : The suppressor is switched to the next
position (only possible with the 733.0030
IC Separation Center).
•
Zero ON/OFF : The auto-zero is switched on or off.
• Pump RUN/STOP : The 709 IC Pump is started or stopped.
Log data transmission
The data transmission logging is used for error diagnosis if the com-
munication between PC and 732 IC Detector is faulty. Normally, it
should not be used because the data transmission rate is lowered.
• Select Equipment setup of the Options menu.
• In the Configured equipment control drivers window, click on 732 IC
Detector[ COM# ] and afterwards on Setup . The INITIAL tab in the 732
IC Detector[ COM# ] window is opened.
• Open the
Serial port[ COM# ]
tab.
• Select the log type:
Formatted I/O : The data transmission between PC and 732 IC
Detector 732 is logged line by line.
Byte stream : The data transmission between PC and 732 IC
Detector 732 is logged character by character
(1 character per line).
File : The data transmission logging is saved into the
MemDump.log file in the program directory.