Metrohm 714 IC Metrodata - Manual (Page 11)

2.2 Software installation
IC Metrodata for Win95
5
2.2 Software installation
The installation program copies the files from the installation diskettes
to the drive and directory you specify and creates the following sub-
directories:
Data Directory for data files ( *.chw )
Methods Directory for method files ( *.mtw )
Reports Directory for report files (without extension)
and graphic files ( *.wmf )
Installation with Windows 95
1) Start Windows 95. Find a drive that has at least 4 MB free storage
space.
2) Insert installation disk into drive A.
3) In the Start menu, select the menu item
Run
and enter
a:setup
. Fol-
low the instructions of the setup program.
4) Make a backup copy of your installation diskettes.
Update from version 1.38 and 1.38a
1) During the installation (see above), specify a new directory for the
program.
2) Copy the old data and method files into the subdirectories Data
and Methods in the new program directory.
3) Delete the old program directory.
Full program version and demo version
The 6.2145.010 Dongle is part of the standard equipment of the
6.6027.153 full program version. Install this dongle into LPT port 1 or 2
(see section 1.3).
The 6.6027.158 demonstration version of "IC Metrodata for Win95" con-
tains only the software without dongle. With this version no chroma-
tograms can be acquired, but all other functions are identical with the
full program version. You can upgrade your demo version at any time if
you install a 6.2145.010 Dongle into the LPT port.
Registration
Please send us your 8.714.8067 Registration card as soon as possible
so we can register you as an official user. Only registered users will get
updated program versions at a special price.
The data files *.chw and the method files *.mtw are not write-
protected. To prevent these files from being deleted by mistake,
switch on the write-protection or make a backup copy in another
directory.