Metrohm 774 Oven Sample Processor - Manual (Page 129)

5.11 Description of the remote control commands
774 Oven Sample Processor, Instructions for use 123
ActHeight: Current lift position
Beaker: Beaker exists at tower X (yes/no)
5.11.3.7 Info.ActualInfo.Rack.Code read only
Info.ActualInfo.Rack.Type read only
Info.ActualInfo.Rack.WorkHeight read only
Info.ActualInfo.Rack.RinseHeight read only
Info.ActualInfo.Rack.ShiftHeight read only
Info.ActualInfo.Rack.SpecialHeight read only
Info.ActualInfo.Rack.ActPos read only
Info.ActualInfo.Rack.Act2Pos read only
Current rack data.
Code:
Identification code of the mounted rack
Type: Rack type
WorkHeight: Working position
RinseHeight: Rinsing position
ShiftHeight: Shifting position
SpecialHeight: Special position
ActPos:
Current rack position at tower 1
Act2Pos: Current rack position at tower 2
5.11.3.8 Info.ActualInfo.Valve.State read only
Current valve state (on/off).
5.11.3.9 Info.ActualInfo.Pump.State read only
Current pump state (on/off).
5.11.3.10 Info.ActualInfo.OutHeater.State read only
Current status of the outlet heater of the transfer hose (on/off). The outlet
heater is 'on' when the oven control is activated, i.e. as soon as a HEATER
command is triggered either manually or in a sequence. The outlet heater is
also activated on switch-on if an initial temperature is set. It is switched off
automatically with a "HEATER off' command.
5.11.3.11 Info.ActualInfo.Fan.State read only
Current fan state (on/off).
5.11.3.12 Info.ActualInfo.Heating.State read only
Current value of the manipulated variable (control deviation) of the oven
heater (0…50).
5.11.3.13 Info.ActualInfo.Buret.1.State read only
Info.ActualInfo.Buret.1.Position read only
Info.ActualInfo.Buret.1.Cock read only
Info.ActualInfo.Buret.1.Type read only
Info.ActualInfo.Buret.1.Volume read only
etc. until .12
Current data of dosing drive.
State: Status
(ready/busy)
Position: Piston position in mL
Cock: Cock position
Type: Type of dosing unit (685/700)
Volume: Burette volume