Rockwell Automation Logix5000 Logix5000 Controllers Quick Start - Manual (Page 114)

114 Publication 1756-QS001E-EN-P - October 2009
Chapter 7 Go Online to the Controller
5. Click the Port Configuration tab.
6. Depending on your device, either:
• Select the Static button.
• Clear (uncheck) the Obtain IP Address from BOOTP Server check box.
7. Type the:
• IP address.
• subnet mask.
• gateway address (if required).
8. Click OK and then click Yes.
Assign an IP Address to Your Computer
If your EtherNet/IP network is a standalone network and your EtherNet/IP device uses IP address and
subnet mask values, you may need to change the IP address and subnet mask values for your computer.
1. Choose Start > Settings > Network and Dial-up Connections.
2. Right-click on Local Area Connection.
3. Choose Properties.