Rockwell Automation Logix5000 Logix5000 Controllers Quick Start - Manual (Page 111)

Publication 1756-QS001E-EN-P - October 2009 111
Go Online to the Controller Chapter 7
Equipment and Information That You Need
1. Depending on your controller, you may need a communication module or daughter card.
2. Determine if your EtherNet/IP network is connected to the Internet or if it is a standalone network
that does not connect to the Internet?
3. For the EtherNet/IP device (controller, bridge module, or daughter card), obtain the following:
Obtain this If your network is connected to the
Internet, from this source If your network is a standalone network
that does not connect to the Internet, from
this source
Ethernet address Sticker on the device Sticker on the device
IP address Network administrator 192.168.1.x, where x = any value between 1
and 254
(1)
(1) In this case, your computer must use an IP address that is close to the EtherNet/IP device’s IP address. For example, if the EtherNet/IP device uses the 192.168.1.x
addressing, the computer must also use that addressing but with a different x value.
Subnet mask
255.255.255.0
(2)
(2) In this case, your computer must use the same subnet mask value as the EtherNet/IP device.
Gateway address (may not be required) Not needed