Rockwell Automation 1394 SERCOS Interface Multi-Axis Motion Control System - Manual (Page 10)

Publication 1394-IN024B-EN-P — February 2004
1-2 Commissioning Your 1394 SERCOS Interface System
General Startup
Precautions The following precautions pertain to all of the procedures in this
chapter. Be sure to read and thoroughly understand them before
proceeding.
ATTENTION
!
This product contains stored energy devices. To
avoid hazard of electrical shock, verify that all
voltages on the system bus network have been
discharged before attempting to service, repair or
remove this unit. Only qualified personnel familiar
with solid state control equipment and safety
procedures in publication NFPA 70E or applicable
local codes should attempt this procedure.
ATTENTION
!
This drive contains ESD (Electrostatic Discharge)
sensitive parts and assemblies. You are required to
follow static control precautions when you install,
test, service, or repair this assembly. If you do not
follow ESD control procedures, components can be
damaged. If you are not familiar with static control
procedures, refer to Allen-Bradley publication 8000-
4.5.2, Guarding Against Electrostatic Damage or any
other applicable ESD Protection Handbook.