Rockwell Automation 1394 SERCOS Interface Multi-Axis Motion Control System Installation Manual - Manual (Page 116)

Publication 1394-IN002B-EN-P — February 2004
A-12 Specifications and Dimensions
Axis Module Dimensions
Figure A.4
1394 Axis Module Dimensions
(1394x-AM03, -AM04, and -AM07)
1 Dimension shown is for mounting hardware location and does not reflect the location of the lower slot.
Figure A.5
1394 Axis Module Dimensions (1394x-AM50, -AM50-IH, -AM75, and -AM75-IH)
1 Dimension shown is for mounting hardware location and does not reflect the location of the lower slot.
2 This dimension does not apply to 1394C-AMxx-IH (internal heatsink) axis modules.
350
(13.78)
400
(15.75)
50
(1.97)
25
(0.98)
50
(1.97)
50
(1.97)
385
(15.16)
8 (0.32)
8 (0.31)
8 (0.31)
10.1 (0.4)
15.9 (0.63)
12 (0.47)
350
(13.78)
280
(11.02)
40.13
(1.58)
Fastener
Location 1
Dimensions are in millimeters and (inches)
Mounting Hole Detail
All slots accept M6 or 1/4-20 Mtg. screws.
Important: Additional clearance below the axis module is
necessary to allow for the recommended cable bend radius.
350
(13.78)
400
(15.75)
37.5 (1.48)
75
(2.95)
75
(2.95)
385
(15.16)
8 (0.32)
8 (0.31)
8 (0.31)
10.1 (0.4)
15.9 (0.63)
12 (0.47)
43.69
(1.72)
105
(4.13)
338.1
(13.31)
385
(15.16)
280
(11.02)
2
2
2
Fastener
Location 1
Dimensions are in millimeters and (inches)
Mounting Hole Detail
All slots accept M6 or 1/4-20 Mtg. screws.
65 (2.56)
Heat sink
width
2
Important: Additional clearance below
the axis is necessary to allow for the
recommended cable bend radius.