Rockwell Automation 1333 Drive, 3/4-5HP, 230-575V Series D - Manual (Page 17)

Specifications
Chapter 3
3-6
Optional Remote Control Inputs
The following optional inputs may be connected to the Series D Bulletin
1333 drive at the Control and Signal Wiring Terminal Block.
Two or Three-Wire Start/Stop Control
Forward Reverse Control
Jog
Three Programmable Preset Speed Select Switches
Auxiliary Interlock
Contact Outputs
The following contact outputs are available as standard. Contacts are
isolated from Logic Common and other drive circuitry and have the
following ratings.
Resistive rating: 120V AC or 30V DC, 1 Amp.
Inductive rating: 120V AC or 30V DC, 0.5 Amps.
At Speed: 1 N.O. contact, closed when the drive is at or above
command speed
Run or 1 N.O. contact closed when the drive is running, at
Overload: programmed speed, at 140% of rated output current, or
over the programmable overload level.
No Fault/Fault: 1 set of Form C contacts that change state to indicate that
the drive has received a fault or that a fault is present when
the drive is powered up.
Analog Outputs
0-10V DC or 0-1 mA output programmable from 75-125% of running
frequency.
Drive Displays
Local Displays drive output frequency, equivalent motor
Programming speed, drive output amps and drive control source. May be
and Display toggled to program and display 62 drive parameters.
Panel: Should a fault occur while the drive is running, the panel
will display the fault code.
Bus Charged: Internal neon display to indicate bus voltage is greater than
50V DC.