Rockwell Automation 1441-DYN25-Z Dynamix 2500 Data Collector - Manual (Page 56)

56 Rockwell Automation Publication 1441-UM001B-EN-P - September 2012
Chapter 2 Configuring the Dynamic 2500 Data Collector
Table 13 - Setup Screen Parameter Descriptions
Parameter Description Value
Route Mem Sets the location where the loaded route data is stored. Internal (default)
Storage Card
Timeout The number of minutes the Dynamix 2500 data collector can remain idle
before it shuts itself off to conserve battery power.
Press On/Off to reactivate the instrument following a timeout. The
instrument returns to the point in the program where it was when it shut
off. No stored data will be lost.
Off (default)
5 min
10 min
15 min
20 min
Trigger Sets the Phase/Order input trigger synchronization:
• Laser Tach enables the internal Laser Tachometer when a Phase or
Order measurement is collected.
• External uses the trigger input from the POWER/USB/TRIGGER
connector as the trigger source.
External (default)
Laser Tach
Dflt Units Defines the units of measurement for Offroute standard velocity
measurements.
Important: Used only for Offroute standard velocity measurements.
English (ips) (default)
Metric (mm/s)
Date Format The format of the date displayed in the Dynamix 2500 data collector. MM/DD/YYYY (default)
DD/MM/YYYY
YYYY/MM/DD
Time Zone Sets the time zone.
Only used when using ActiveSync software data synchronization. The time
zone on the instrument must match the time zone on the computer. If you
are not using ActiveSync software then the time zone setting has no
effect.
Important: Always set your instrument to the correct time zone or your
files will not be in sync by time zone.
List of 30 time zones
Date/Time Displays the date and time in the format you select in the Date and Time
parameters. Current data and time
Memory Configures the memory:
• Select cmd to exit this field without selecting an option.
• Delete all routes and data from memory.
• Initialize formats the memory. Deletes all files from memory including
any route files and directories.
Important: These commands are performed on the memory location as
set by Route Memory.
Select cmd (default)
Delete all routes
Initialize
Route Font You can select the font size for the Route. Big or Small
Envelope The type of envelope to use for high frequency and rolling element bearing
analysis.
Determines which pre-defined measurement you can use to collect
Offroute data.
gSE (default), collects an Offroute gSE point.
ESP, collects an Offroute ESP point
Navigation Determines how the instrument navigates through the routes in the Data
Collection screens when the Right arrow key is pressed:
• Enpac- The instrument displays a Selection screen from which you
select the item you want to collect or review.
• DataPac - The instrument functions like a dataPAC 1500 in that it
automatically advances to the next point in the route.
Enpac
DataPac (default)