Rockwell Automation 1441-DYN25-Z Dynamix 2500 Data Collector - Manual (Page 112)

112 Rockwell Automation Publication 1441-UM001B-EN-P - September 2012
Chapter 4 Loading and Unloading
7. Click OK to close the Data Collector Advanced Settings dialog box.
8. Click OK when finished.
Use the descriptions in this table to help you configure the parameters in the
Advanced Settings dialog box.
Table 38 - Data Collector Advanced Settings Parameters
Parameter Description Values
Operating System Sets the operating system version of the data collector.
2CHEnable Enables the Emonitor software to download measurements
configured for 2-channel collection. Yes
No
Current Baud The baud rate for the serial communication.
or the USB this is the default.
Recommend setting this to
115200.
Current Parity The combination of parity, data bits and stop bits. The first
letter in the setting is the parity: None, Even, Odd. The first
number is the number of data bits. The second number is the
number of stop bits. N81 stands for no parity, 8 data bits, and 1
stop bit. The Dynamix 2500 data
collector uses only N81.
Datapac Enumulation Configures the Dynamix 2500 Data Collector to collect data the
same as the Datapac. Yes
No
Direction The default direction to be used for Offroute measurements. 0 - None
1 - Horizontal
2 - Vertical
3 - Axial
Log Display Display plots in log format in the data collector. Yes
No
Machine Speed The default machine speed to use for Offroute measurements.
Phone Number Not Used
Position The default position label to use for Offroute measurements. 1 to 16 characters
Sync Trigger Level The amplitude level for externally triggering the measurement.
This parameter is used when you set Trig Level to `Fixed’ in the
Instrument Setup screen.
See Configure the Data Collection Options on page 57 .
Positive
Negative
Sync Trigger Slope The input signal slope to be used for externally triggering the
measurement.
This parameter is used when you set Trig Level to `Fixed’ in the
Instrument Setup screen.
See Configure the Data Collection Options on page 57 .
Positive
Negative