RKI Instruments Gas Tracer - Manual (Page 59)

Gas Tracer Operator’s Manual Display Mode • 51
The table below illustrates how much data logging time is available
for the various interval times. It assumes that the unit is set up with all
5 sensors and there are no alarm occurrences.
Clear Data Logger Screens
CAUTION: Once you clear the data logger, you cannot retrieve any data
previously stored in the data logger.
NOTE: This item appears in Display Mode only if the DLOG DSP menu
item in Maintenance Mode is turned ON. The factory setting for
DLOG DSP is ON.
The clear data logger screens allow you to clear the data logger
storage. You can set the Gas Tracer to overwrite the oldest data when
the data log is full. See “Updating the Datalog Overwrite Setting” on
page 160. The bottom line of the screen alternates between LG
CLEAR, NO /DISP, and YES/ENT.
To clear the data log:
1. With the above screen displayed, press and release the POWER
ENTER button. The instrument will ask you to confirm that you
want to clear the data log and CLr LOG will be flashing. The
Table 6: Data Logging Capacity, 5 Sensor Gas Tracer
Interval
Time
Data Logging Time
10 seconds 10 hours
20 seconds 20 hours
30 seconds 30 hours
1 minute 60 hours
3 minutes 180 hours
5 minutes 300 hours
10 minutes 600 hours
CLr
LG CLEAR
LOG