RKI Instruments Gas Tracer - Manual (Page 178)

170 • Using Maintenance Mode Gas Tracer Operator’s Manual
Updating the Bar Hole Sampling Time
The Bar Hole Sampling Time is the amount of time that the Gas Tracer
samples a bar hole when being used in Bar Hole Mode. The 3
selections are 30, 45, and 60 seconds. The factory setting is 30 seconds.
1. Use the AIR▲ or (SHIFT)▼ buttons to display the B.H. TIME menu
item.
2. Press and release the POWER ENTER button. The screen will
indicate the current setting.
3. Use the AIR▲ or (SHIFT) ▼ button to display the desired setting.
4. Press and release the POWER ENTER button to save the setting
and return to the main menu.
Updating the Leak Check Mode CO
Channel Display Setting
With CO DISP set to OFF (factory setting), the CO channel is not
displayed in Leak Check Mode but is still displayed in Normal Mode.
With CO DISP set to On, the CO channel will be displayed in Leak
Check Mode but there will be no CO alarms and the CO channel
reading will not be saved to any snap log data taken during the
operating session.
MAINTENANCE
B.H. TIME
30
MAINTENANCE
B.H. TIME