RKI Instruments Gas Tracer - Manual (Page 12)

4 • About this Manual Gas Tracer Operator’s Manual
About this Manual
The Gas Tracer Operator’s Manual uses the following conventions for
notes, cautions, and warnings.
NOTE: Describes additional or critical information.
CAUTION: Describes potential damage to equipment.
WARNING: Describes potential danger that can result in injury or
death.
Safety/
Regulatory
C US
pending
CSA classified, “C/US”, as Intrinsically Safe. Exia. Class I, Groups A,
B, C, & D. Temperature Code T3C.
Power Supply • Three AA size alkaline batteries standard
• Lithium Ion Battery Pack (3.7 VDC Nominal) optional, Direct
Charging
Continuous
Operating Hours
@ 25 °C
• Alkaline Batteries: 15 Hours (Non Alarm Operation, Fully Charged)
• Lithium Ion Battery Pack: 10 Hours (Non alarm Operation, Fully
Charged)
Case High-impact Plastic with protective rubber layer, RF Shielded, Dust
and Weather Proof
Standard
Accessories
• 10 foot hose
• 10 inch probe
• Flexible 4 inch tapered rubber nozzle
Optional
Accessories
• Rechargeable Lithium-Ion Battery Pack
• 115 VAC Charging Station
• 12 VDC Charging Station
• Data Logger Management Program Software
• IrDA/USB Cable for Downloading Data to a Computer With Data
Logger Management Program (not needed if computer has an
infrared port)
• SDM-2102 Automatic Calibration Station & Software
• Various Probes (see “Parts List” on page 190)
Dimensions and
Weight
Approximately 171(H) x 65(W) x 39(D) mm (5.6”H x 2.5”W x 1.5”D)
Approximately 310 g (11 oz.)
*Some versions of the Gas Tracer are available with the LEL and/or PPM sensors factory
set for HC (general hydrocarbons) and calibrated to isobutane. Consult RKI Instruments,
Inc. for further information.