MacDon D60 Draper Headers User Manual
Page 81
SECTION 8. MAINTENANCE AND SERVICING
Form 169441
79
Revision B
A
8.4.2 NON-HINGED
a. To remove the
endshield, press
against latch in
opening at (A) on
inboard side of
endsheet.
b. Lift up on shield, pull out and back to remove
shield.
c. To install shield, locate forward end in crop
divider (B), and position shield over endsheet.
Pin (C) at top of endsheet must engage shield.
d. Push in shield where shown (opposite latch), and
shield will self-latch.
8.4.2.1 Adjustments
NOTE
Plastic endshields are subject to
expansion or contraction depending on
large temperature variations. Latch pin
can be adjusted to compensate for
dimensional changes.
a. Remove
endshield.
b. Loosen
bolts
(D).
c. Adjust the pin assembly (E) to achieve the gap
‘X’ between the front end of the shield and the
header frame in accordance with the following
chart.
TEMPERATURE
Degrees ˚F (
˚C)
GAP ‘X’
Inches (mm)
25 (- 4)
1.1 (28)
45 (7)
1.0 (24)
65 (18)
0.79 (20)
85 (29)
0.64 (16)
105 (41)
0.5 (12)
125 (52)
0.32 (8)
145 (63)
0.16 (4)
165 (89)
0
d. Tighten bolts (D).
(continued next page)
C
B
D
E
X