MacDon D60 Draper Headers - Manual (Page 64)

SECTION 7. OPERATION
Form 169441 62 Revision B
7.20 UPPER CROSS AUGER
The cross auger helps deliver very bulky crops
across the header onto the windrow.
Removable beater bars assist in delivering
material through the header opening.
If wrapping occurs, the beater bars can be
removed as shown in the next column.
a. Lower header to ground, stop engine, and
remove key.
WARNING
Stop engine, and remove key before removing
plugged material from header. A child or even
a pet could engage the drive.
b. Remove bolts (A) securing bars (B) and clamps
(C) to auger tubes, and remove bars and clamps.
To re-install the beater bars:
a. Locate one beater bar (B) with one clamp set (C)
on auger tube, and loosely secure with carriage
bolt (A) and nut. Bolt head must face direction of
auger rotation.
b. Locate remaining clamp sets on tube, and loosely
attach to beater bar with carriage bolts and nuts.
Bolt heads must face direction of auger rotation.
c. Position second beater bar in clamps, and secure
with carriage bolts and nuts.
d. Tighten bolts.
C
A
B
SINGLE REEL HEADERS
DOUBLE REEL HEADERS
A
C
B