MacDon D60 Draper Headers - Manual (Page 27)

SECTION 7. OPERATION
Form 169441 25 Revision B
c. Disconnect the header drive hydraulics as
follows:
1. Disengage and rotate lever (C) counter
clockwise to fully up position.
2. Disconnect electrical connector from header.
3. Disconnect hoses from header as follows:
i. Line up slot (J) in collar with pin (K) on
connector.
ii. Push collar toward pin, and pull
connector to disengage.
iii. Install caps on connectors and hose
ends (if equipped).
4. Route hose bundle (A) back onto hose
support on windrower.
5. Rotate lever (C), and lock in down position.
6. Install cap (D) on electrical connector.
d. Detach header from windrower. Refer to the
M150/M200 or M205 Self-Propelled Windrower
Operator’s Manual.
K
J
C
C
D
A